Product Overview
About: Taramps Bass 5K 5000 Watts RMS Class D Car Amplifier - 1 Ohm (Taramp's Authorized Canadian Dealer)
The BASS 5K amplifier from Taramps was carefully developed with the highest technology, income and performance for automotive sound systems and made specifically for subwoofer and bass responses, in the frequency range from 8Hz to 250Hz. It has a maximum power of 5000 Watts in 1 channel of 1 ohm, with customized adjustments according to the size of the trunk and the frequency of most prominent of each vehicle, through the BASS BOOST and the option of choosing the central frequency. This amplifier module can offer much more control of excessive displacement, through SUBSONIC FILTER, volume control and LOW PASS, to make your bass in the right measure. Welcome to the sound world of Taramps!
| OPERATION CLASS | D |
|---|---|
| NUMBER OF CHANNELS | 01 |
| MAXIMUM POWER | @ 14.4 VDC - 1 Ohm: 5000 Watts RMS@ 14.4 VDC - 2 Ohms: 3200 Watts RMS |
| INPUT SENSITIVITY | 220mV |
| SIGNAL TO NOISE RATIO | >95dB |
| FREQUENCY RESPONSE | 8Hz ~ 250Hz (-3dB) |
| CROSSOVER HIGH PASS (HPF) | 8Hz ~ 30Hz (-12dB/8ª) Variable |
| CROSSOVER LOW PASS (LPF) | 60Hz ~ 250Hz (-12dB/8ª) Variable |
| BASS BOOST | freq.: 35Hz ~ 60Hz / Boost: 0 ~ +10dB |
| EFFICIENCY | 83% |
| INPUT IMPEDANCE | 15K Ohms |
| OUTPUT IMPEDANCE | 1 Ohm |
| PROTECTION SYSTEM | Short-Circuit to Output, Short on output compared to GND, Low impedance at output, High/Low supply voltage and Thermal protection |
| MIN. SUPPLY VOLTAGE | 9 VDC |
| MAXIMUM POWER SUPPLY VOLTAGE | 17 VDC |
| CONSUMPTION AT REST | 1.20A |
| MAXIMUM MUSIC CONSUMPTION | 209A |
| MAXIMUM CONSUMPTION IN SINUSOIDAL SIGNAL | 418A |
| DIMENSIONS (H X W X D) | 9.41" x 2.87" x 12.87" (239 x 73 x 327mm) |
| WEIGHT | 11lb (5kg) |
| EAN | 7898556844765 |
Precautions
- Do not mount amplifier to speaker box. Cyclic Vibrational Failure is #1 fail rate of amplifiers and these are lighter than most so their potential is higher if not followed.
- Do not wire this amplifier lower than 1ohm nominal Impedance. (Equivalent to ~0.7 ohms DCR or Resistive measurement via DMM).
- Do not clip amplifier above 15.0v for extended periods of time
- Do not drive amplifier into clipping + protection for extended periods of time (exceeding 20% THD)
