Taramps HD3000 High Power Car Amplifier


(No reviews yet) Write a Review

Log in for pricing

Usually Ships in 1-2 Days

Product Overview

Taramps High Voltage Amplifier HD3000 W -  3,000 Watts RMS - Taramps Authorized Canadian Dealer 

High Definition and Maximum Performance – These high power line of amplifiers from Brazil bring you the best in engineering and power for your extreme car audio installations. Taramp’s has a well-deserved reputation for building high-quality, high-power mobile audio products. The HD Series amps are some of the best-selling models, with variable high and low pass filters (crossovers), extreme durability, while delivering more reliable performance at standard car voltage on the market today.


  • Number of Channels: 01
  • Max. Output Power @ 13,8 VDC - 1 OHM: 3598W RMS
  • Max. Output Power @ 13,8 VDC - 2 OHMS: 2446W RMS
  • Max. Output Power @ 13,8 VDC - 4 OHMS: 1403W RMS
  • Max. Output Power @ 12,6 VDC - 1 OHM: 3000W RMS
  • Max. Output Power @ 12,6 VDC - 2 OHMS: 2040W RMS
  • Max. Output Power @ 12,6 VDC - 4 OHMS: 1170W RMS
  • Input Sensitivity: 250mV @ -9,78 dBm
  • Total Harmonic Distortion (THD) 0,3%
  • Signal / Noise Ratio: >95dB
  • Damping Factor: 300
  • Frequency Response (Full Range): 5Hz a 15KHz
  • H.P.F (High Pass Filter): 5Hz a 50Hz (-12dB/Octave) Variable
  • L.P.F (Low Pass Filter): 50Hz a 15KHz (-12dB/Octave) Variable
  • Bass Boost: 0 to 10dB (50Hz)
  • Input Impedance: 18K OHMS
  • Protection System: Short into Output / Power Supply High/Low
  • Minimum Supply Voltage: 10,5VDC
  • Maximum Supply Voltage: 16VDC
  • Idle Consumption: 1,70 Amp.
  • Musical Maximum Consumption @ 12,6VDC: 170 Amp.
  • Sinusoidal Signal Maximum Consumption @ 12,6 VDC: 340 Amp.
  • Dimensions (WxHxD): 229 x 65 x 288mm
  • Weight: 3,11Kg


  • Do not mount amplifier to speaker box.  Cyclic Vibrational Failure is #1 fail rate of amplifiers and these are lighter than most so their potential is higher if not followed.
  • Do not wire this amplifier lower than 1ohm nominal Impedance. (Equivalent to ~0.7 ohms DCR or Resistive measurement via DMM).
  • Do not clip amplifier above 15.0v for extended periods of time
  • Do not drive amplifier into clipping + protection for extended periods of time (exceeding 20% THD)




(No reviews yet) Write a Review