Product Overview
About: Taramps High Voltage Amplifier MD 12000.1 W - 1 Ohm 12,000 Watts RMS (Taramps Authorized Canadian Dealer)
Taramps presents the amplifier module MD 12000.1 in the 1 ohm version. It has been carefully developed with the highest technology, offering high performance and quality for the most varied automotive sound systems, serving the entire frequency range, in other words, it is a FULL RANGE module. It is an amplifier classified as mono, has a channel with a maximum power of 12000 Watts RMS. Welcome to the sound world of Taramps.
Technical Information
| OPERATION CLASS | Class D |
|---|---|
| NUMBER OF CHANNELS | 01 |
| MAXIMUM POWER | @ 12,6 VDC - 1 OHM: 12000W RMS @ 12,6 VDC - 2 OHMS: 7200W RMS |
| INPUT SENSITIVITY | 220mV |
| SIGNAL TO NOISE RATIO | >95dB |
| FREQUENCY RESPONSE | 10Hz ~ 5KHz(-3dB) |
| CROSSOVER HIGH PASS (HPF) | 10Hz ~ 90Hz (-12dB/8ª) Variable |
| CROSSOVER LOW PASS (LPF) | 90Hz ~ 5KHz (-12dB/8ª) Variable |
| BASS BOOST | 35Hz ~ 55Hz 0 ~ 10dB |
| EFFICIENCY | 80% |
| INPUT IMPEDANCE | 15K OHMS |
| OUTPUT IMPEDANCE | 1 OHM |
| PROTECTION SYSTEM | Short-Circuit to Output, Short on output compared to GND, low impedance at output, High/Low supply voltage and thermal protection |
| MIN. SUPPLY VOLTAGE | 9 VDC |
| MAXIMUM POWER SUPPLY VOLTAGE | 16 VDC |
| CONSUMPTION AT REST | 4 A |
| MAXIMUM MUSIC CONSUMPTION | 595 A |
| MAXIMUM CONSUMPTION IN SINUSOIDAL SIGNAL | 1190 A |
| DIMENSIONS (H X W X D) | 8.98" x 2.76" x 21.65" |
| WEIGHT | 17.50lb |
| EAN | 7898556844840 |
Precautions
- Do not mount amplifier to speaker box. Cyclic Vibrational Failure is #1 fail rate of amplifiers and these are lighter than most so their potential is higher if not followed.
- Do not wire this amplifier lower than 1ohm nominal Impedance. (Equivalent to ~0.7 ohms DCR or Resistive measurement via DMM).
- Do not clip amplifier above 15.0v for extended periods of time
- Do not drive amplifier into clipping + protection for extended periods of time (exceeding 20% THD)
