Product Overview
About: Taramps Smart 3 Bass Car Amplifier (Taramps Authorized Canadian Dealer)
The Smart 3 BASS is yet another innovation for automotive sound systems from Taramps. The exclusive Power Control System technology now specific for subwoofers, ensuring even more quality at low frequencies with more security by monitoring the entire operation of the amplifier. It’s an single channel multi-impedance amplifier, that is, it delivers the 3000 WRMS of power in any impedance between 0.5 and 2 ohms. It has an indicative logo that you already know, robust power input, supporting cables from 21mm to 50mm and output for CLIP monitor. Immerse yourself in this new experience with the Taramps Group!
Technical Information:
| OPERATION CLASS | Class D |
|---|---|
| NUMBER OF CHANNELS | 01 |
| MAXIMUM POWER | @ 14.4 VDC - 0.5 Ohm: 3000 Watts RMS @ 14.4 VDC - 1 Ohm: 3000 Watts RMS @ 14.4 VDC - 2 Ohms: 3000 Watts RMS @ 14.4 VDC - 4 Ohms: 1700 Watts RMS |
| INPUT SENSITIVITY | 4V ~ 0.2V |
| SIGNAL TO NOISE RATIO | >90dB |
| FREQUENCY RESPONSE | 8Hz ~ 200Hz (-3dB) |
| CROSSOVER HIGH PASS (HPF) | 8Hz ~ 30Hz (-12dB/8ª) Variable |
| CROSSOVER LOW PASS (LPF) | 60Hz ~ 200Hz (-12dB/8ª) Variable |
| BASS BOOST | Freq.: 35Hz ~ 60HzBoost: 0 ~ +10dB |
| EFFICIENCY | 75% |
| INPUT IMPEDANCE | 10K Ohms |
| OUTPUT IMPEDANCE | 0.5 ~2 ohms |
| PROTECTION SYSTEM | Output short-circuit low/high supply voltage thermal protection |
| MIN. SUPPLY VOLTAGE | 9 VDC |
| MAXIMUM POWER SUPPLY VOLTAGE | 17 VDC |
| CONSUMPTION AT REST | 1.10 A |
| MAXIMUM MUSIC CONSUMPTION | 190A |
| MAXIMUM CONSUMPTION IN SINUSOIDAL SIGNAL | 278A |
| DIMENSIONS (H X W X D) | 9.37" x 2.80" x 9.45" (238 x 71 x 240mm) |
| WEIGHT | 6.60lb (3Kg) |
| EAN | 7898556847414 |
- Do not mount amplifier to speaker box. Cyclic Vibrational Failure is #1 fail rate of amplifiers and these are lighter than most so their potential is higher if not followed.
- Do not wire this amplifier lower than 1ohm nominal Impedance. (Equivalent to ~0.7 ohms DCR or Resistive measurement via DMM).
- Do not clip amplifier above 15.0v for extended periods of time
- Do not drive amplifier into clipping + protection for extended periods of time (exceeding 20% THD)
