Product Overview
About Timpano TPT-5000EQ Monoblock Car Audio Amplifier 1 and 2 Ohm
The TPT-5000EQ offer 1 channel with advanced individual equalization features for Bass, Mid Bass and Mid High, plus the traditional Level, High Pass and Low Pass features. Its Full Range frequency response from 10Hz to 25KHz allows the installation of Subwoofers, Woofers, Drivers and Tweeters.
Technical Information
| TPT-5000EQ 1 Ohm | TPT-5000EQ 2 Ohm | |
| Number of Channels | 01 | 01 |
| RMS Power @ 12.6 Volts | @ 12.6 VDC - 1 OHM: 5000W | @ 12.6 VDC - 2 OHM: 5000W @ 12.6 VDC - 4 OHMS: 3050W |
| RMS Power @ 14.4 Volts | @ 14.4 VDC - 1 OHM: 5600W @ 14.4 VDC - 2 OHMS: 3400W | @ 14.4 VDC - 2 OHM: 5500W @ 14.4 VDC - 4 OHMS: 3550W |
| Supply Voltage | 9.5 ~ 15V | 9.5 ~ 15V |
| Frequency Response | 10Hz ~ 15KHz | 10Hz ~ 15KHz |
| Crossover Low Pass (LPF) | 50Hz ~ 15KHZ | 50Hz ~ 15KHz |
| Crossover High Pass (HPF) | 10Hz ~700Hz | 10Hz ~ 700Hz |
| Signal to Noise Ratio | >90dB | >90dB |
| Harmonic Distortion | <0.9% THD | < 0.9 % THD |
| Input Sensitivity | 0.2 V | 0.2V |
| Input Impedance | 26K Ohms | 26K Ohms |
| Impedance Output | 1 Ohm | 2 Ohms |
| Consumption with Signal Musical | 4.1A ~ 245A | 3.1A ~ 240A |
| Consumption with Signal Bass | 4.1A ~ 490A | 3.1A ~ 480A |
| Dimensions (L x W x H) | 11.57” x 12.20” x 3” | 11.57” x 12.20” x 3” |
| Weight | 9LBS | 9LBS |
You must follow the instructions for the product’s installation and connections to guarantee optimal performance. If you have any questions, get in touch with us. Before using the amplifier, always follow these guidelines:
• Make sure the amplifier is switched off before adding or removing any connections. This prevents possible damage to equipment.
• Keep all cables as far away as possible from the ignition cables, electronic injection modules and starter switch since they may cause noise interference;
• Always use 100% Copper wire and good quality connectors. This guarantees reliability and performance.
• To avoid damaging the cables, make sure that they do not touch sharp metal edges. Important: For this amp use a 60A fuse 12 inches away from the battery as a safety precaution
The power rated data are based on equipment from the STETSOM laboratory. Frequency reference of 1Khz with THD+N to ≤10% in impedances referring to the indicated in each measurement. The electronic components and the manufacturing can present manufacturing variations, thus leading to a variation in the measurements made. This amplifier is designed to preform on music applications (with speakers), any load test (Resistant load) is not recommended.
